Chapter 79 Networked AV Mode
XMG1930 Series User’s Guide
631
A console port access control session and Telnet access control session cannot coexist when multi-login
is disabled. See the CLI Reference Guide for more information on disabling multi-login.
This section describes how to control access to the Switch.
79.37.1 What You Can Do
• Use the Service Access Control screen (Section 79.38 on page 631) to decide what services you may
use to access the Switch.
• Use the Remote Management screen (Section 79.39 on page 632) to specify a group of one or more
“trusted computers” from which an administrator may use a service to manage the Switch.
79.38 Service Access Control
Service Access Control allows you to decide what services you may use to access the Switch. You may
also change the default service port and configure “trusted computers” for each service in the Remote
Management screen (discussed earlier). Click SECURITY > Access Control > Service Access Control to
view the screen as shown.
Figure 465 SECURITY > Access Control > Service Access Control
The following table describes the fields in this screen.
Table 363 SECURITY > Access Control > Service Access Control
LABEL DESCRIPTION
Services Services you may use to access the Switch are listed here.
Active Enable the switch button for the corresponding services that you want to allow to access the
Switch.
To Next Page
Loading...
