Chapter 79 Networked AV Mode
XMG1930 Series User’s Guide
620
To access this screen, click the Add/Edit button or select an entry from the list and click the Add/Edit
button.
Figure 453 SWITCHING > Multicast > IGMP Snooping VLAN > Add/Edit
The following table describes the labels in this screen.
79.31 IGMP Filtering Profile
An IGMP filtering profile specifies a range of multicast groups that clients connected to the Switch are
able to join. A profile contains a range of multicast IP addresses which you want clients to be able to
join. Profiles are assigned to ports (in the SWITCHING > Multicast > IGMP Snooping screen). Clients
connected to those ports are then able to join the multicast groups specified in the profile. Each port
can be assigned a single profile. A profile can be assigned to multiple ports.
Click SWITCHING > Multicast > IGMP Filtering Profile link to display the screen as shown.
Figure 454 SWITCHING > Multicast > IGMP Filtering Profile
Table 352 SWITCHING > Multicast > IGMP Snooping VLAN > Add/Edit
LABEL DESCRIPTION
Name Enter the descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ ,
])of the VLAN for identification purposes.
VID Enter the ID of a static VLAN; the valid range is between 1 and 4094.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
To Next Page
Loading...
