Chapter 6 Tutorials
XMG1930 Series User’s Guide
115
Setting Up the Switch
1 Open the Web Configurator. Go to the MAINTENANCE > Configuration > Auto Configuration screen.
2 Enable the switch button in the Active field to enable auto configuration. Select DHCP in the Mode field
and click Apply to save your changes.
3 Enable the switch button in the Active field to enable auto configuration. Select DHCP in the Mode field,
and enter the VLAN ID where the DHCP server belongs to in the DHCP VLAN ID field. Click Apply to save
your changes.
4 Go to the SYSTEM > IP Setup > IP Setup screen. Click the Add/Edit button in the IP Interface table to open
the configuration screen.
5 Select DHCP Client.
6 If you want to load the auto configuration file with DHCP option 60 enabled and a Vendor Class
Identifier assigned when you reboot the Switch, follow the instruction below. Otherwise, skip this step. In
the SYSTEM > IP Setup > IP Setup > Add/Edit screen, select the check box in the Option-60 field. Enter a
Vendor Class Identifier in the Class-ID field, and specify the VLAN interface in the VID field. In this
example, we use “Zyxel Corp” and VID 1. Click Apply.
To Next Page
Loading...
