Chapter 27 Switch Setup
XMG1930 Series User’s Guide
205
Figure 133 Basic Setting > Switch Setup (Without Access L3 License)
Figure 134 SYSTEM > Switch Setup (With Access L3 License)
The following table describes the labels in this screen.
Table 92 SYSTEM > Switch Setup
LABEL DESCRIPTION
VLAN Type Choose 802.1Q or Port Based. The SWITCHING > VLAN link and its sub-links only appears when
you choose 802.1Q VLAN type in this screen.
Bridge Control
Protocol
Transparency
Enable the ON/OFF switch to allow the Switch to handle bridging control protocols (STP, for
example). You also need to define how to treat a BPDU in the PORT > Port Setup screen.
MAC Address Learning
MAC address learning reduces outgoing traffic broadcasts. For MAC address learning to occur on a port, the port
must be active.
To Next Page
Loading...
