Chapter 36 OAM
XMG1930 Series User’s Guide
262
The following table describes the fields in the above screen.
Table 125 PORT > OAM > OAM Remote Loopback
LABEL DESCRIPTION
Remote Loopback Test
Port Enter the number of the port from which the Switch performs a remote-loopback test.
Number of Packet Define the allowable packet number of the loopback test frames.
Packet Size Define the allowable packet size of the loopback test frames.
Test Click Test to begin the test.
Remote Loopback Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to initiate
or terminate a remote-loopback test.
Start Click Start to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.
To Next Page
Loading...
