Chapter 53 Spanning Tree Protocol
XMG1930 Series User’s Guide
353
Use the this screen to activate one of the STP modes on the Switch. Click SWITCHING > Spanning Tree
Protocol > Spanning Tree Setup to display the screen as shown.
Figure 243 SWITCHING > Spanning Tree Protocol > Spanning Tree Setup (Without Access L3 License)
Figure 244 SWITCHING > Spanning Tree Protocol > Spanning Tree Setup (With Access L3 License)
Up to 5 Gbps 4000
More than 5 Gbps 2000
Table 184 Auto Path Cost Mode: User-defined
LINK SPEED AUTO PATH COST VALUE
To Next Page
Loading...
