Chapter 56 VLAN
XMG1930 Series User’s Guide
383
56.2.0.3 VLAN Priority
At the time of writing, you can create static VLANs, Voice VLANs and Vendor ID-based VLANs on the
Switch when the VLAN type is set to 802.1Q. When a packet is received, the Switch processes the VLAN
rules in sequence. The sequence (priority) of the VLANs is:
1 Vendor ID Based VLAN
2 Voice VLAN
3 Subnet Based VLAN
4 Protocol Based VLAN
5 MAC Based VLAN
If the packet matches a VLAN rule that has a higher priority, for example, an entry with weight 250 in the
vendor ID to VLAN mapping table, the Switch assigns the corresponding VLAN ID to the packet and
stops checking the subsequent VLAN rules.
56.2.0.4 Select the VLAN Type
Select a VLAN type in the SYSTEM > Switch Setup screen.
Figure 266 SYSTEM > Switch Setup: Select VLAN Type (Without Access L3 License)
To Next Page
Loading...
