ZyXEL Communications ZyWALL 2 Plus - Firewall Default Rule (Bridge Mode); Figure 126 SECURITY > FIREWALL > Default Rule (Bridge Mode)

Chapter 11 Firewall
ZyWALL 2 Plus User’s Guide
193
11.8 Firewall Default Rule (Bridge Mode)
Click SECURITY > FIREWALL to open the Default Rule screen.
Use this screen to configure general firewall settings when the ZyWALL is set to bridge mode.
See Section 11.1 on page 181 for more information about the firewall.
Figure 126 SECURITY > FIREWALL > Default Rule (Bridge Mode)
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 50 SECURITY > FIREWALL > Default Rule (Router Mode) (continued)
LABEL DESCRIPTION