Chapter 33 Remote Node Setup
ZyWALL 2 Plus User’s Guide
495
Figure 319 Menu 11.1.4: Remote Node Filter (PPPoE or PPTP Encapsulation)
33.6 Traffic Redirect
Configure parameters that determine when the ZyWALL will forward WAN traffic to the
backup gateway using Menu 11.1.5 - Traffic Redirect Setup.
Figure 320 Menu 11.1.5: Traffic Redirect Setup
The following table describes the fields in this menu.
Menu 11.1.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.1.5 - Traffic Redirect Setup
Active= Yes
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 14
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 10
Period(sec)= 300
Timeout(sec)= 8
Press ENTER to Confirm or ESC to Cancel:
Table 193 Menu 11.1.5: Traffic Redirect Setup
FIELD DESCRIPTION
Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
Configuration
Backup Gateway IP
Address
Enter the IP address of your backup gateway in dotted decimal notation.
The ZyWALL automatically forwards traffic to this IP address if the ZyWALL's
Internet connection terminates.
Metric This field sets this route's priority among the routes the ZyWALL uses.
Enter a number from 1 to 15 to set this route's priority among the ZyWALL's
routes (see Section 8.2 on page 141) The smaller the number, the higher
priority the route has.
To Next Page
Loading...
