Chapter 18 Static Route
ZyWALL 2 Plus User’s Guide
326
Figure 211 ADVANCED > STATIC ROUTE > IP Static Route
The following table describes the labels in this screen.
18.2.1 IP Static Route Edit
Select a static route index number and click Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.
Table 98 ADVANCED > STATIC ROUTE > IP Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Name This is the name that describes or identifies this route.
Active This field shows whether this static route is active (Yes) or not (No).
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the ZyWALL’s interface. The gateway helps forward packets to
their destinations.
Modify Click the edit icon to go to the screen where you can set up a static route on the
ZyWALL.
Click the delete icon to remove a static route from the ZyWALL. A window displays
asking you to confirm that you want to delete the route.
To Next Page
Loading...
