Chapter 33 Remote Node Setup
ZyWALL 2 Plus User’s Guide
491
33.3.2.3 Metric
See Section 8.2 on page 141 for details on the Metric field.
33.3.3 PPTP Encapsulation
If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen.
Table 190 Fields in Menu 11.1 (PPPoE Encapsulation Specific)
FIELD DESCRIPTION
Service Name If you are using PPPoE encapsulation, then type the name of your PPPoE service
here. Only valid with PPPoE encapsulation.
Authen This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this
remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Telco Option
Allocated
Budget
The field sets a ceiling for outgoing call time for this remote node. The default for this
field is 0 meaning no budget control.
Period(hr) This field is the time period that the budget should be reset. For example, if we are
allowed to call this remote node for a maximum of 10 minutes every hour, then the
Allocated Budget is (10 minutes) and the Period(hr) is 1 (hour).
Schedules You can apply up to four schedule sets here. For more details please refer to
Chapter 43 on page 575.
Nailed-Up
Connection
This field specifies if you want to make the connection to this remote node a nailed-
up connection. More details are given earlier in this section.
Session
Options
Idle Timeout Type the length of idle time (when there is no traffic from the ZyWALL to the remote
node) in seconds that can elapse before the ZyWALL automatically disconnects the
PPPoE connection. This option only applies when the ZyWALL initiates the call.
To Next Page
Loading...
