Chapter 31 DMZ Setup
ZyWALL 2 Plus User’s Guide
481
" DMZ, WLAN and LAN IP addresses must be on separate subnets. You must
also configure NAT for the DMZ port (see Chapter 35 on page 499) in menus
15.1 and 15.2.
31.3.2 IP Alias Setup
Use menu 5.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to open Menu 5.2.1 - IP Alias Setup, as
shown next. Use this menu to configure the second and third networks.
Figure 309 Menu 5.2.1: IP Alias Setup
Refer to Table 185 on page 473 for instructions on configuring IP alias parameters.
Menu 5.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
To Next Page
Loading...
