ZyXEL Communications ZyWALL 2 Plus - Configuring the WAN Connection with a Static IP Address; Figure 42 Tutorial Example: WAN Connection with a Static Public IP Address

Chapter 4 Tutorial
ZyWALL 2 Plus User’s Guide
94
4.2.2 Configuring the WAN Connection with a Static IP Address
The following table shows the information your ISP gave you for Internet connection.
Follow the steps below to configure your ZyWALL for Internet access using PPPoE in this
example.
Figure 42 Tutorial Example: WAN Connection with a Static Public IP Address
1 Click NETWORK > WAN > WAN.
2 Select PPPoE (PPP over Ethernet) from the Encapsulation drop-down list box.
3 In the ISP Parameters for Internet Access section, enter the information (such as the
user name and password) provided by your ISP. If your ISP didn’t give you the service
name, leave the field blank.
4 In the WAN IP Address Assignment section, select Use Fixed IP Address and enter the
first fixed public IP address (1.2.3.4 in this example).
5 Click Apply.
Encapsulation PPPoE
Public IP Addresses 1.2.3.4
1.2.3.5
1.2.3.6
1.2.3.7
Gateway IP Address 1.2.3.89
Subnet Mask 255.255.255.0
User Name exampleuser
Password abcd1234
DNS Server 1.2.1.1
1.2.1.2