ZyWALL 2 Plus User’s Guide
655
APPENDIX J
Certificates Commands
The following describes the certificate commands. See Appendix G on page 639 for
information on the command structure.
All of these commands start with certificates.
Table 241 Certificates Commands
COMMAND DESCRIPTION
my_cert
create
create selfsigned
<name>
<subject>
[key size]
Create a self-signed local host certificate.
<name> specifies a descriptive name for the
generated certificate. <subject> specifies a
subject name (required) and alternative name
(required). The format is "subject-name-
dn;{ip,dns,email}=value". If the name contains
spaces, please put it in quotes. [key size]
specifies the key size. It has to be an integer
from 512 to 2048. The default is 1024 bits.
create request
<name>
<subject>
[key size]
Create a certificate request and save it to the
router for later manual enrollment. <name>
specifies a descriptive name for the generated
certification request. <subject> specifies a
subject name (required) and alternative name
(required). The format is "subject-name-
dn;{ip,dns,email}=value". If the name contains
spaces, please put it in quotes. [key size]
specifies the key size. It has to be an integer
from 512 to 2048. The default is 1024 bits.
create scep_enroll
<name> <CA
addr> <CA
cert> <auth
key>
<subject>
[key size]
Create a certificate request and enroll for a
certificate immediately online using SCEP
protocol. <name> specifies a descriptive name
for the enrolled certificate. <CA addr> specifies
the CA server address. <CA cert> specifies the
name of the CA certificate. <auth key> specifies
the key used for user authentication. If the key
contains spaces, please put it in quotes. To
leave it blank, type "". <subject> specifies a
subject name (required) and alternative name
(required). The format is "subject-name-
dn;{ip,dns,email}=value". If the name contains
spaces, please put it in quotes. [key size]
specifies the key size. It has to be an integer
from 512 to 2048. The default is 1024 bits.
To Next Page
Loading...
