Link Aggregation Configuration Example 115
Network diagram
Figure 38 Network diagram for link aggregation configuration
Configuration procedure
n
The following example only lists the configuration required on Switch A; you must
perform the same configuration proceedure on Switch B to implement link
aggregation.
1 Adopting manual aggregation mode
# Create manual aggregation group 1.
<4210> system-view
[4210] link-aggregation group 1 mode manual
# Add Ethernet1/0/1 through Ethernet1/0/3 to aggregation group 1.
[[4210] interface Ethernet1/0/1
[4210-Ethernet1/0/1] port link-aggregation group 1
[4210-Ethernet1/0/1] quit
[4210] interface Ethernet1/0/2
[4210-Ethernet1/0/2] port link-aggregation group 1
[4210-Ethernet1/0/2] quit
[4210] interface Ethernet1/0/3
[4210-Ethernet1/0/3] port link-aggregation group 1
2 Adopting static LACP aggregation mode
# Create static aggregation group 1.
<4210> system-view
[4210] link-aggregation group 1 mode static
# Add Ethernet1/0/1 through Ethernet1/0/3 to aggregation group 1.
[4210] interface Ethernet1/0/1
[4210-Ethernet1/0/1] port link-aggregation group 1
[4210-Ethernet1/0/1] quit
[4210] interface Ethernet1/0/2
[4210-Ethernet1/0/2] port link-aggregation group 1
[4210-Ethernet1/0/2] quit
[4210] interface Ethernet1/0/3
Switch A
Link aggregation
Switch B
Switch A
Link aggregation
Switch B
To Next Page
Loading...
