116 CHAPTER 10: LINK AGGREGATION CONFIGURATION
[4210-Ethernet1/0/3] port link-aggregation group 1
3 Adopting dynamic LACP aggregation mode
# Enable LACP on Ethernet1/0/1 through Ethernet1/0/3.
<4210> system-view
[4210] interface Ethernet1/0/1
[4210-Ethernet1/0/1] lacp enable
[4210-Ethernet1/0/1] quit
[4210] interface Ethernet1/0/2
[4210-Ethernet1/0/2] lacp enable
[4210-Ethernet1/0/2] quit
[4210] interface Ethernet1/0/3
[4210-Ethernet1/0/3] lacp enable
c
CAUTION: The three LACP-enabled ports can be aggregated into one dynamic
aggregation group to implement load sharing only when they have the same basic
configuration (such as rate, duplex mode, and so on).
To Next Page
Loading...
