310 CHAPTER 28: QOS CONFIGURATION
cos(802.1p) : 0 1 2 3 4 5 6 7
-----------------------------------------------------------------------
local precedence(queue) : 0 0 1 1 2 2 3 3
Configuring Port Rate
Limiting
Refer to “Port Rate Limiting” on page 305 for information about port rate
limiting.
Configuration prerequisites
■ The port on which port rate limiting configuration is to be performed is
determined.
■ The target rate and the direction of rate limiting (inbound or outbound) are
determined.
Configuration procedure
Configuration example
■ Configure port rate limiting for inbound packets on Ethernet 1/0/1.
■ The rate limit is 1,024 Kbps
Configuration procedure:
<4210> system-view
[4210] interface Ethernet1/0/1
[4210-Ethernet1/0/1] line-rate inbound 1024
Configuring Queue
Scheduling
Refer to “Queue Scheduling” on page 305 for information about queue
scheduling.
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters are
determined.
Tabl e 233 Configure port rate limiting
Operation Command Description
Enter system view system-view -
Enter Ethernet port
view
interface interface-type
interface-number
-
Configure port rate
limiting
line-rate { inbound |
outbound } target-rate
Required
By default, port rate limiting is disabled.
To Next Page
Loading...
