Cluster Configuration Example 335
[4210] ntdp enable
[4210] interface Ethernet 1/1
[4210-Ethernet1/1] ntdp enable
[4210-Ethernet1/1] quit
# Enable the cluster function.
[4210] cluster enable
2 Configure the management device
# Enable NDP globally and on Ethernet 1/0/2 and Ethernet 1/0/3.
<4210> system-view
[4210] ndp enable
[4210] interface Ethernet 1/0/2
[4210-Ethernet1/0/2] ndp enable
[4210-Ethernet1/0/2] quit
[4210] interface Ethernet 1/0/3
[4210-Ethernet1/0/3] ndp enable
[4210-Ethernet1/0/3] quit
# Set the holdtime of NDP information to 200 seconds.
[4210] ndp timer aging 200
# Set the interval to send NDP packets to 70 seconds.
[4210] ndp timer hello 70
# Enable NTDP globally and on Ethernet 1/0/2 and Ethernet 1/0/3.
[4210] ntdp enable
[4210] interface Ethernet 1/0/2
[4210-Ethernet1/0/2] ntdp enable
[4210-Ethernet1/0/2] quit
[4210] interface Ethernet 1/0/3
[4210-Ethernet1/0/3] ntdp enable
[4210-Ethernet1/0/3] quit
# Set the topology collection range to 2 hops.
[4210] ntdp hop 2
# Set the member device forward delay for topology collection requests to 150
ms.
[4210] ntdp timer hop-delay 150
# Set the member port forward delay for topology collection requests to 15 ms.
[4210] ntdp timer port-delay 15
# Set the interval to collect topology information to 3 minutes.
[4210] ntdp timer 3
# Enable the cluster function.
[4210] cluster enable
# Enter cluster view.
[4210] cluster
[4210-cluster]
# Configure a private IP address pool for the cluster. The IP address pool contains
six IP addresses, starting from 172.16.0.1.
[4210-cluster] ip-pool 172.16.0.1 255.255.255.248
To Next Page
Loading...
