492 CHAPTER 44: DEVICE MANAGEMENT
Network diagram
Figure 171 Network diagram for FTP configuration
Configuration procedure
1 Configure the following FTP server-related parameters on the PC: an FTP user with
the username as switch and password as hello, who is authorized with the
read-write right on the directory Switch on the PC. The detailed configuration is
omitted here.
2 On the switch, configure a level 3 telnet user with the username as user and
password as hello. Authentication mode is by user name and password.
n
Refer to “Logging into an Ethernet Switch” on page 21 for configuration
commands and steps about using telnet.
3 Execute the telnet command on the PC to log into the switch. The following
prompt appears:
<4210>
c
CAUTION: If the Flash memory of the switch is not sufficient, delete the original
applications before downloading the new ones.
4 Initiate an FTP connection with the following command in user view. Enter the
correct user name and password to log into the FTP server.
<4210> ftp 2.2.2.2
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):switch
331 Give me your password, please
Password:*****
230 Logged in successfully
[ftp]
5 Enter the authorized path on the FTP server.
[ftp] cd switch
6 Execute the get command to download the switch.bin and boot.btm files on the
FTP server to the Flash memory of the switch.
[ftp] get switch.bin
[ftp] get boot.btm
7 Execute the quit command to terminate the FTP connection and return to user
view.
[ftp] quit
<4210>
8 Upgrade the Boot ROM.
<4210> boot bootrom boot.btm
This will update BootRom file on unit 1. Continue? [Y/N] y
To Next Page
Loading...
