3Com 4210 PWR - Page 504

502 CHAPTER 45: REMOTE-PING CONFIGURATION
4 Configuring HTTP test on Remote-Ping client
Configure the source port source-port port-number Optional
By default, no source port is
configured.
Configure the test type test-type ftp Required
By default, the test type is
ICMP.
Configure the number of
probes per test
count times Optional
By default, each test makes
one probe.
Configure the maximum
number of history records that
can be saved
history-records number
Figure 174 Optional
By default, the maximum
number is 50.
Configure the automatic test
interval
frequency interval Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test
will be made.
Configure the probe timeout
time
timeout time Optional
By default, a probe times out
in three seconds.
Configure the type of service tos value Optional
By default, the service type is
zero.
Configure the type of FTP
operation
ftp-operation { get | put } Optional
By default, the type of FTP
operation is get, that is, the
FTP operation will get a file
from the FTP server.
Configure an FTP login
username
username name Required
By default, neither username
nor password is configured.
Configure an FTP login
password
password password
Configure a file name for the
FTP operation
filename file-name Required
By default, no file name is
configured for the FTP
operation
Start the test test-enable Required
Display test results display Remote-Ping
results [ admin-name
operation-tag ]
Required
You can execute the
command in any view.
Table 374 Configure FTP test on Remote-Ping client
Operation Command Description
Tabl e 375 Configure HTTP test on Remote-Ping client
Operation Command Description
Enter system view system-view -