3Com 4210 PWR - Page 503

Remote-Ping Configuration 501
3 Configuring FTP test on Remote-Ping client
Enable the Remote-Ping client
function
Remote-Ping-agent enable Required
By default, the Remote-Ping
client function is disabled.
Create a Remote-Ping test
group and enter its view
Remote-Ping
administrator-name
operation-tag
Required
By default, no test group is
configured.
Configure the source
interface
source-interface
interface-type
interface-number
Required
You can only configure a
VLAN interface as the source
interface.
By default, no source interface
is configured.
Configure the test type test-type dhcp Required
By default, the test type is
ICMP.
Configure the number of
probes per test
count times Optional
By default, each test makes
one probe.
Configure the maximum
number of history records that
can be saved
history-records number
Figure 173 Optional
By default, the maximum
number is 50.
Configure the probe timeout
time
timeout time Optional
By default, a probe times out
in three seconds.
Start the test test-enable Required
Display test results display Remote-Ping
results [ admin-name
operation-tag ]
Required
You can execute the
command in any view.
Table 373 Configure DHCP test on Remote-Ping client
Operation Command Description
Tab le 374 Configure FTP test on Remote-Ping client
Operation Command Description
Enter system view system-view -
Enable the Remote-Ping client
function
Remote-Ping-agent enable Required
By default, the Remote-Ping
client function is disabled.
Create a Remote-Ping test
group and enter its view
Remote-Ping
administrator-name
operation-tag
Required
By default, no test group is
configured.
Configure the destination IP
address
destination-ip ip-address Required
By default, no destination
address is configured.
Configure the source IP
address
source-ip ip-address Required
By default, no source IP
address is configured.