3Com 4210 PWR - Page 508

506 CHAPTER 45: REMOTE-PING CONFIGURATION
7 Configuring TCP test on Remote-Ping client
Configure the source IP
address
source-ip ip-address Optional
By default, no source IP
address is configured.
Configure the source port source-port port-number Optional
By default, no source port is
configured.
Configure the test type test-type snmpquery Required
By default, the test type is
ICMP.
Configure the number of
probes per test
count times Optional
By default, each test makes
one probe.
Configure the maximum
number of history records that
can be saved
history-records number
Figure 176 Optional
By default, the maximum
number is 50.
Configure the automatic test
interval
frequency interval Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test
will be made.
Configure the probe timeout
time
timeout time Optional
By default, a probe times out
in three seconds.
Configure the type of service tos value Optional
By default, the service type is
zero.
Start the test test-enable Required
Display test results display Remote-Ping
results [ admin-name
operation-tag ]
Required
You can execute the
command in any view.
Table 377 Configure SNMP test on Remote-Ping client
Operation Command Description
Tabl e 378 Configure TCP test on Remote-Ping client
Operation Command Description
Enter system view system-view -
Enable the Remote-Ping client
function
Remote-Ping-agent enable Required
By default, the Remote-Ping
client function is disabled.
Create a Remote-Ping test
group and enter its view
Remote-Ping
administrator-name
operation- tag
Required
By default, no test group is
configured.