Remote-Ping Configuration 507
Configure the destination
address
destination-ip ip-address Required
This IP address and the one
configured on the
Remote-Ping server for
listening services must be the
same.
By default, no destination
address is configured.
Configure the destination
port
destination-port
port-number
Required in a Tcpprivate test
A Tcppublic test is a TCP
connection test on port 7. Use
the Remote-Ping-server
tcpconnect ip-address 7
command on the server to
configure the listening service
port; otherwise the test will
fail. No port number needs to
be configured on the client;
any destination port number
configured on the client will
not take effect.
By default, no destination port
number is configured.
Configure the source IP
address
source-ip ip-address Optional
By default, the source IP
address is not specified.
Configure the source port source-port port-number Optional
By default, no source port is
specified.
Configure the test type test-type { tcpprivate |
tcppublic }
Required
By default, the test type is
ICMP.
Configure the number of
probes per test
count times Optional
By default, one probe is made
per time.
Configure the automatic test
interval
frequency interval Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test
will be made.
Configure the probe timeout
time
timeout time Optional
By default, a probe times out
in three seconds.
Configure the maximum
number of history records that
can be saved
history-records number
Figure 177 Optional
By default, the maximum
number is 50.
Configure the type of service tos value Optional
By default, the service type is
zero.
Start the test test-enable Required
Table 378 Configure TCP test on Remote-Ping client
Operation Command Description
To Next Page
Loading...
