508 CHAPTER 45: REMOTE-PING CONFIGURATION
8 Configuring UDP test on Remote-Ping client
Display test results display Remote-Ping results [
admin-name operation-tag ]
Required
The display command can be
executed in any view.
Table 378 Configure TCP test on Remote-Ping client
Operation Command Description
Tabl e 379 Configure UDP test on Remote-Ping client
Operation Command Description
Enter system view system-view -
Enable the Remote-Ping client
function
Remote-Ping-agent enable Required
By default, the Remote-Ping
client function is disabled.
Create a Remote-Ping test
group and enter its view
Remote-Ping
administrator-name
operation- tag
Required
By default, no test group is
configured.
Configure the destination
address
destination-ip ip-address Required
This IP address and the one
configured on the
Remote-Ping server for
listening service must be the
same.
By default, no destination
address is configured.
Configure the destination
port
destination-port
port-number
■ Required in a Udpprivate
test
■ A Udppublic test is a UDP
connection test on port 7.
Use the
Remote-Ping-server
udpecho ip-address 7
command on the server to
configure the listening
service port; otherwise the
test will fail. No port
number needs to be
configured on the client;
any destination port
number configured on the
client will not take effect.
■ By default, no destination
port number is configured.
Configure the source IP
address
source-ip ip-address Optional
By default, no source IP
address is configured.
Configure the source port source-port port-number Optional
By default, no source port is
specified.
Configure the test type test-type { udpprivate |
udppublic }
Required
By default, the test type is
ICMP.
To Next Page
Loading...
