RIP 115
Perform the following configurations in RIP View.
Specifying the Operating State of the Interface
In the Interface View, you can specify whether RIP update packets are sent and
received on the interface. In addition, you can specify whether an interface sends
or receives RIP update packets.
Perform the following configuration in Interface View:
The undo rip work command and the undo network command have similar but
not the same functions. The
undo rip work command allows other interfaces to
forward the route of the interface applying this command. The
undo network
command prevents other interfaces from forwarding the route of the interface
applying this command, and it appears that this interface has been removed.
In addition, the rip work command is functionally equivalent to both the rip
input
and rip output commands.
By default, all interfaces except loopback interfaces both receive and transmit RIP
update packets.
Disabling Host Route
In some cases, the router can receive many host routes from the same segment,
and these routes are of little help in route addressing but consume a lot of
network resources. Routers can be configured to reject host routes by using the
undo host-route command.
Perform the following configurations in RIP View.
By default, the router receives the host route.
Tab le 109 Configuring Zero Field Check of the Interface Packets
Operation Command
Configure zero field check on the RIP-1 packet checkzero
Disable zero field check on the RIP-1 packet undo checkzero
Tab le 110 Specifying the Operating State of the Interface
Operation Command
Enable the interface to run RIP rip work
Disable the interface from running RIP undo rip work
Enable the interface to receive RIP update packets rip input
Disable the interface from receiving RIP update packets undo rip input
Enable the interface to send RIP update packets rip output
Disable the interface from sending RIP update packets undo rip output
Tab le 111 Disabling Host Route
Operation Command
Enable receiving host route host-route
Disable receiving host route undo host-route
To Next Page
Loading...
Need help?
General