3Com Switch 4500 26-Port

To Next Page

To Previous Page

Related Documentation 13

Documentation

The 3Com Switch 4500 Getting Started Guide provides information about

installation.

The 3Com Switch 4500 Command Reference Guide provides all the information

you need to use the configuration commands.

Main Page

Default Chapter1
- Default Chapter1
  - Configuration Guide1
  - Table of Contents3
- About this Guide13
1 Getting Started17
- Product Overview17
- Stacking Overview18
  - Brief Introduction18
  - Typical Networking Topology18
- Product Features18
- Logging in to the Switch19
- Command Line Interface26
  - Command Line View26
  - Features and Functions of Command Line30
- User Interface Configuration32
2 Port41
- Ethernet Port Configuration41
- Link Aggregation Configuration49
3 Vlan Operation59
- VLAN Configuration59
- Voice VLAN Configuration63
- Configuring Voice VLAN with a PC Downstream from Phone67
4 Power over Ethernet Configuration75
- Poe Overview75
- Poe Configuration76
5 Network Protocol Operation81
- IP Address Configuration81
- ARP Configuration85
- DHCP Configuration88
- Access Management Configuration95
- UDP Helper Configuration98
- IP Performance Configuration101
  - Displaying and Debugging IP Performance102
  - Troubleshooting IP Performance102
6 Ip Routing Protocol Operation105
- IP Routing Protocol Overview105
  - Selecting Routes through the Routing Table106
  - Routing Management Policy107
- Static Routes108
- Rip112
- IP Routing Policy123
7 Acl Configuration131
- Brief Introduction to ACL131
- 8 Igmp Snooping155
- 9 Stacking163
10 Rstp Configuration169
- STP Overview169
11 Configuration191
- IEEE 802.1X Overview191
- AAA and RADIUS Protocol Configuration204
12 File System229
- File System Overview229
- Configuring File Management231
13 MAC Address Table Management241
- Overview241
- MAC Address Table Configuration242
14 Device Management246
- Overview246
- Device Management Configuration246
15 System251
- Aintenance and Debugging251
- Basic System Configuration251
- Introduction to Remote-Ping256
- Remote-Ping Configuration257
- Logging Function259
16 Snmp Configuration281
- Overview281
- SNMP Versions and Supported MIB281
- Configuring SNMP282
- Displaying and Debugging SNMP286
- SNMP Configuration Example287
  - Reading Usmusr Table Configuration Example289
17 Rmon C291
- Overview291
- Configuring RMON291
18 Ntp Configuration295
- Overview295
19 Ssh Terminal Services313
- SSH Terminal Service313
20 Password Control Configuration Operations341
- Introduction to Password Control Configuration341
- Password Control Configuration343
- Configuring the Minimum Password Length345
- Configuring History Password Recording345
- Configuring User Login Password in Encryption Mode346
- Configuring Login Attempts Limitation and Failure Procession Mode346
- Configuring the Timeout for User Password Authentication347
- Displaying Password Control348
- Password Control Configuration Example348
  - Network Requirements348
  - Configuration Procedure349
Password Recovery Process351
- Introduction351
- CLI Commands Controlling Bootrom Access351
- Bootrom Interface352
- Setting up a RADIUS Server355
- Setting up the RADIUS Client384
Uthenticating the389
- Cisco Secure ACS (TACACS+) and the 3Com Switch 4500389
- Setting up the Cisco Secure ACS (TACACS+) Server389

Table of Contents

Related product manuals