EasyManua.ls Logo

3Com Switch 4500 26-Port

3Com Switch 4500 26-Port
396 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
306 CHAPTER 18: NTP CONFIGURATION
# Enter system view.
<SW4500-2> system-view
[SW4500-2]
# Enter Vlan-interface2 view.
[SW4500-2] interface Vlan-interface 2
[SW4500-2-Vlan-interface2]
# Set SW4500-2 to a broadcast client.
[SW4500-2-Vlan-interface2] ntp-service broadcast-client
After the above configurations, SW4500-1 and SW4500-2 will listen to broadcast
packets through their own Vlan-interface2, and Switch3 will send broadcast
packets through Vlan-interface2. Because SW4500-2 and Switch3 do not share
the same network segment, SW4500-2 cannot receive broadcast packets from
Switch3, while SW4500-1 is synchronized to Switch3 after receiving broadcast
packets from Switch3.
View the status of SW4500-1 after synchronization.
[SW4500-1] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 3.0.1.31
Nominal frequency: 250.0000 Hz
Actual frequency: 249.9992 Hz
Clock precision: 2^19
Clock offset: 198.7425 ms
Root delay: 27.47 ms
Root dispersion: 208.39 ms
Peer dispersion: 9.63 ms
Reference time: 17:03:32.022 UTC Thu Sep 6 2001 (BF422AE4.05AEA86C)
The output information indicates that SW4500-1 is synchronized to Switch3, with
the clock stratum level of 3, one level lower than that of Switch3.
# View the information about the NTP sessions of SW4500-1 and you can
see that a connection is established between SW4500-1 and Switch3.
[SW4500-1] display ntp-service sessions
source reference stra reach poll now offset delay disper
**************************************************************************
[1]3.0.1.31 127.127.1.0 2 1 64 377 26.1 199.53 9.7
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Configuring NTP
Multicast Mode
Network requirements
The local clock of Switch3 is set to the NTP master clock, with a clock stratum level
of 2. Switch3 advertises multicast packets through Vlan-interface2.
SW4500-1 and SW4500-2 respectively listen to multicast packets through their
own Vlan-interface2.
This example assumes that Switch3 is a switch that supports the local clock being
the master clock.

Table of Contents

Related product manuals