Logging In to the Switch 17
Logging In to the
Switch
Setting up
Configuration
Environment Through
the Console Port
1 To set up the local configuration environment, connect the serial port of a PC (or a
terminal) to the console port of the Switch with the console cable (see
Figure 2).
Figure 2 Setting up the Local Configuration Environment through the Console Port
2 Run terminal emulator (such as Terminal on Windows 3X or the Hyper Terminal on
Windows 9X) on the PC. Set the terminal communication parameters as follows:
â– Baud rate = 19200
Security features Multi-level user management and password protect
802.1X authentication
Packet filtering
Quality of Service (QoS) Traffic classification
Bandwidth control
Priority
Queues of different priority on the port
Management and
Maintenance
Command line interface configuration
Configuration through console port
Remote configuration through Telnet or SSH
Configuration through dialing the Modem
SNMP
Level alarms
Output of debugging information
Ping and Tracert
Remote maintenance with Telnet, Modem and SSH
Loading and updates Loading and upgrading of software through the XModem
protocol
Loading and upgrading of software through File Transfer
Protocol (FTP) and Trivial File Transfer Protocol (TFTP)
Table 4 Function Features
Features Description
Console por
Console cable
To Next Page
Loading...
Need help?
General