Logging Function 271
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select debugging as the information type when configuring information
source, meantime using the
debugging command to turn on the debugging
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Tab le 306 Configuring the Output Format of Time-stamp
Sending the Information
to SNMP Network
Management
To send information to SNMP NM, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Tab le 307 Enabling/Disabling Info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following operation in System View.
Tab le 308 Configuring to Output Information to SNMP NM
3 Configuring the information source on the Switch.
With this configuration, you can define the information that is sent to SNMP NM:
generated by which modules, information type, information level, and so on.
Perform the following operation in System View.
Operation Command
Configure the output format of
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled undo info-center timestamp { log | trap |
debugging }
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Operation Command
Output information to SNMP NM info-center snmp channel {
channel-number | channel-name }
Cancel the configuration of outputting
information to SNMP NM
undo info-center snmp channel
To Next Page
Loading...
Need help?
General