332 CHAPTER 19: SSH TERMINAL SERVICES
Table 360 Configure the service type to be used
By default, the service type is stelnet.
2 Starting the SFTP server
Perform the following configuration in system view.
Table 361 Start the SFTP server
By default, the SFTP server is shut down.
SFTP Client
Configuration
SFTP client configuration tasks are described in this section:
Operation Command
Configure the service type to be used ssh user username service-type {
stelnet | sftp | all }
Restore the default service type undo ssh user username service-type
Operation Command
Start the SFTP server sftp server enable
Shut down the SFTP server undo sftp server
To Next Page
Loading...
