EasyManuals Logo

3Com Switch 4500 26-Port User Manual

3Com Switch 4500 26-Port
396 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #264 background imageLoading...
Page #264 background image
262 CHAPTER 15: SYSTEM MAINTENANCE AND DEBUGGING
Table 283 Sending the Information to Log Buffer
4 Sending the Information to trap buffer.
Table 284 Sending the Information to Trap Buffer
5 Sending the Information to SNMP
Table 285 Sending the Information to SNMP
6 Turn on/off the information synchronization Switch in Fabric
Device Configuration Default Value Configuration Description
Switch
Enable info-center By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information output
direction to logbuffer
- You can configure the size of the
log buffer at the same time.
Set information source - You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the Switch of the
corresponding module before
defining output debugging
information.
Device Configuration Default Value Configuration Description
Switch
Enable info-center By default, info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to
trapbuffer
You can configure the size of
the trap buffer at the same time.
Set information source You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the Switch of the
corresponding module before
defining output debugging
information.
Device Configuration Default value Configuration description
Switch
Enable info-center By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is
enabled.
Set the information output
direction to SNMP
- -
Set information source - You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the Switch of the
corresponding module before
defining output debugging
information.
Configuring SNMP features - See SNMP Configuration
Network
management
workstation
The same as the SNMP
configuration of the Switch
- -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 3Com Switch 4500 26-Port and is the answer not in the manual?

3Com Switch 4500 26-Port Specifications

General IconGeneral
Brand3Com
ModelSwitch 4500 26-Port
CategorySwitch
LanguageEnglish

Related product manuals