Logging Function 265
Tab le 289 Enable/disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to the control terminal.
Perform the following operation in System View.
Tab le 290 Configuring to Output Information to Control Terminal
3 Configuring the information source on the Switch.
With this configuration, you can define the information sent to the control
terminal that is generated by which modules, information type, information level,
and so on.
Perform the following operation in System View:
Tab le 291 Defining Information Source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels;
severity specifies the severity level of information.
The information with the level below it will not be output.
channel-number
specifies the channel number and channel-name specifies the channel name.
When defining the information sent to the control terminal, channel-number or
channel-name must be set to the channel that corresponds to the Console
direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select debugging as the information type when configuring information
source, meantime using the
debugging command to turn on the debugging
Switch of those modules.
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Operation Command
Output information to Console info-center console channel{
channel-number | channel-name }
Cancel the configuration of
outputting information to Console
undo info-center console channel
Operation Command
Define information source info-center source { modu-name | default }
channel { channel-number | channel-name } [ {
log | trap | debug }* { level severity |
state state }* ]
Cancel the configuration of
information source
undo info-center source { modu-name | default
} channel { channel-number | channel-name }
To Next Page
Loading...
Need help?
General