32 CHAPTER 1: GETTING STARTED
Perform the following configurations in User Interface (AUX user interface only)
View.
Configuring the Transmission Speed on the AUX (Console) Port
By default, the transmission speed on the AUX (console) port is 19200bps.
Configuring the Flow Control on the AUX (Console) Port
By default, the flow control on the AUX (console) port is none, that is, no flow
control will be performed.
Configuring Parity on the AUX (Console) Port
By default, the parity on the AUX (console) port is none, that is, no parity bit.
Configuring the Stop Bit of AUX (Console) Port
By default, the AUX (console) port supports 1 stop bit.
Configuring the Data Bit of the AUX (Console) Port
By default, the AUX (console) port supports 8 data bits.
Table 12 Configuring the Transmission Speed on the AUX (Console) Port
Operation Command
Configure the transmission speed on the AUX
(console) port
speed speed_value
Restore the default transmission speed on the AUX
(console) port
undo speed
Table 13 Configuring the Flow Control on the AUX (Console) Port
Operation Command
Configure the flow control on the AUX (console) port flow-control { hardware |
none | software }
Restore the default flow control mode on the AUX
(console) port
undo flow-control
Table 14 Configuring Parity on the AUX (Console) Port
Operation Command
Configure parity mode on the AUX (console)
port
parity { even | mark | none |
odd | space }
Restore the default parity mode undo parity
Table 15 Configuring the Stop Bit of AUX (Console) Port
Operation Command
Configure the stop bit of the AUX (console) port stopbits { 1 | 1.5 | 2 }
Restore the default stop bit of the AUX (console) port undo stopbits
Table 16 Configuring the Data Bit of the AUX (Console) Port
Operation Command
Configure the data bit of the AUX (console) port databits { 7 | 8}
Restore the default data bit of the AUX (console) port undo databits
To Next Page
Loading...
Need help?
General