40 CHAPTER 2: PORT OPERATION
Entering Ethernet Port View
Before configuring an Ethernet port, enter Ethernet Port View.
Perform the following configuration in System View.
Enabling/Disabling an Ethernet Port
Use the following command to disable or enable the port. After configuring the
related parameters and protocol of the port, you can use the following command
to enable the port. If you do not want a port to forward data, use the command
to disable it.
Perform the following configuration in Ethernet Port View.
By default, the port is enabled.
Setting the Description Character String for the Ethernet Port
To distinguish the Ethernet ports, use the following command to assign a
description to each port.
Perform the following configuration in Ethernet Port View.
By default, the port description is a null character string.
Setting the Duplex Attribute of the Ethernet Port
To configure a port to send and receive data packets at the same time, set it to
full-duplex. To configure a port to either send or receive data packets, set it to
half-duplex. If the port has been set to auto-negotiation mode, the local and peer
ports will automatically negotiate the duplex mode.
Perform the following configuration in Ethernet Port View.
Table 30 Entering Ethernet Port View
Operation Command
Enter Ethernet Port View interface { interface_type
interface_num | interface_name }
Table 31 Enabling/Disabling an Ethernet Port
Operation Command
Disable an Ethernet port shutdown
Enable an Ethernet port undo shutdown
Table 32 Setting the Description Character String for the Ethernet Port
Operation Command
Set description character string for Ethernet port. description text
Delete the description character string of Ethernet. undo description
Table 33 Setting the Duplex Attribute for the Ethernet Port
Operation Command
Set duplex attribute for Ethernet port. duplex { auto | full | half }
Restore the default duplex attribute of Ethernet port. undo duplex
To Next Page
Loading...
Need help?
General