3D Systems BFB-3000 - Page 33

BFB-3000 Set Up and Operations Manual
Document No: D100253 33
 Load the type of materials into their reel positions according to the number of
extruders in the BFB-3000:
Number of extruders in
the BFB-3000
Material for
Extruder 1
Material for
Extruder 2
Material for Extruder 3
1
ABS or PLA
2
ABS
PLA
3
ABS
PLA
Not needed in first print
 After positioning the reels:
1
Insert the filaments into the
appropriate delivery tubes
(identified in Figure 5, page 32)
Feed
filaments up
to extruders
2
Example for this
section: BFB-3000
with two extruders.
PLA
ABS