3M Edge eg5 - Docking Station Operation; Charging the Dosimeter

Docking station functionality
Charging your dosimeter
14
Charging your dosimeter
The number of hours you have used your dosimeter from your last charge will impact your total charge
time. For example, if the battery clock indicator (see “Checking the battery power” for more information)
displays 20 hours remaining on the battery and you wish to charge the battery, the approximate charging
time is 2 hours.
NOTE: To charge a fully discharged battery, it would take approximately 3 to 3.5 hours.
 How to charge
1. Plug in the power adapter to the EdgeDock. (See power adapter below.)
 The EdgeDock’s lower LED will appear solid when powered on.
2. Slide the Edge (see 1) downward onto the Hook of the EdgeDock until it clicks. It will be fully
seated. (See 2 in Figure below).
 NOTE: The top LED will appear as red flashing or solid green when fully charged.
Figure 2-7: Docking the Edge on the EdgeDock
1. Backside of Edge:
The open cavity & contacts slides into the “Hook” of
EdgeDock. The contacts will align to each other.
2. Example of the Edge Charging
Power adapter
Dosimeter Charge status’(Upper LED):
 Flashing Red LED when charging
 Solid Green LED when fully charged
EdgeDock station status (Lower LED)
 Flashing Red when charging
 Solid Green LED when fully charged.
 Amber LED indicates dock is powered on but
Edge is not docked.
Docking station LED
Hook
Contacts
Dosimeter LED dock