3M Edge eg5 - Docking Operations; Customizing Setup Parameters in DMS

Customizing set-up parameters in DMS
22
4. For first time use of a docking station, Welcome to the found new hardware wizard will appear (see
Figure 2-8). Select No and press Next through the remaining wizard. At the end of the wizard, press
Finish.
 This will install the hardware components associated with your EdgeDock1 and/or EdgeDock5.
 NOTE: If you have more than one EdgeDock1 or EdgeDock5, this wizard will appear for each new
dock which is connected to your pc.
Figure 3-5: New Hardware wizard for Edge Dock
Customizing set-up parameters in DMS
Customizing and saving set-ups are performed via DMS. The following sections discuss each of the setup screens
and explain how to save and send the parameters to the dosimeter(s).
 NOTE: The following DMS settings apply to the eg5 model. If you are also using other models (eg3/eg4) and
have them docked in a 5-bay charger, they will appear in the “Edge Bay Charger” tree section, but no checkbox
will appear unless you first select the eg3/eg4 models radio buttons. The checkbox denotes that the models are
selectable when setup changes are applied and the “send setup to instruments” or “get identity” buttons are
selected.