Hard Hat Attachment Kit
The following instructions explain how to assemble and attach the hard hat kit to a standard hard hat.
Using a 3/32” hex wrench, twist the top shoulder bolt counterclockwise to loosen and remove the bolt
and the clip. Also, remove the bottom clip with the hex wrench. Once the bottom clip is removed, place
the shoulder bolt back into its place and tighten back up with the hex wrench.
Place the epaulette mount (see “A” above) into the top bracket of the Edge. Then slide the bolt into place
and tighten with a hex wrench. Then, the epaulette mount snaps onto the bottom shoulder bolt.
Slide the two prongs of the hard hat mount (see “B” above) underneath the epaulette mount (see “A
above) until it clicks into place.
4. Taking the Edge with the assembled hard hat attachments, slide into the side of hard hat. It will fit
snuggly into the hard hat opening.
To Next Page
Loading...
