Firmware update
Edge firmware updates are performed in DMS when the instruments are docked, communicating, and the update key is selected. Please
follow the steps below prior to updating your Edge(s). Note: this feature enables you to update all of your docked Edges (when powered
on and not in run mode).
1. Click on the Firmware tab from the Instrument Configuration panel (see 1) and ensure to dock the Edge (or Edges) . Please read
steps under “Firmware Update” prior to updating (see 2).
Press button to refresh the docked instruments (if necessary).
2. Press the button and please wait until the software states that it is Done. (Example of the message: ).
3. To set, save and send to the Edge (for more details see “Saving and sending configurations”.
Figure 3-10: Edge firmware update screen
To Next Page
Loading...
