3M Edge eg5 - Customizing Setup Parameters; Saving and Sending Configurations

Customizing set-up parameters in DMS
Saving and sending configurations
27
Saving and sending configurations
With the Edge, there are saved setup profiles used to quickly access and apply to The Edge(s). Below explains how to save
configuration settings in DMS and how to send to the instrument. Note: if you wish to only send the setup, please skip to step 3. Please
refer to this section as you setup your instrument.
1. To save the Edge configuration in the software, click on a name in the Configuration Profile Management panel (See 1). (Note:
The name will be shaded a light gray when selected.)
 To create a new profile name, click and type in a profile name. Click Save. (It will save under the configuration profile
management panel).
2. Click on the button (see 2) and type in a Name. Click Ok.
 Note: This saves the configuration file in the software.
 Or click button and rename the setting by typing in a name. Click Ok.
3. To send to the instrument, select the (see 3).
Figure 3-11: Saving and sending Edge setups
2
3
4
Setups:
Click on the tabs to setup/view:
 Dosimeter, Display, Security,
Auto Run, and Firmware Update
1