Protected Station: Software > Remote Activation
This page provides the mechanism to activate software on all remote protected stations.
The Software Pack has been loaded into the base station with the file transfer process (see ‘Protected
Station: Software > Primary File Transfer’ on page 375) and distributed via the radio link to all remote radios
from the active radio.
When all remote radios receive the Software Pack version, the software can be remotely activated on all
remote radios.
The activation process is monitored by this page.
This page is only available when the radio is configured as a Base Station.
REMOTE SOFTWARE ACTIVATION
When the software pack version has been distributed to all the remote radios, the software is then activated
in all the remote radios with this command. If successful, then activate the software pack in the base station
to complete the network upgrade.
Version
This parameter displays the software version for activation. The default version is the software pack version
but any valid software version can be entered in the format ‘n.n.n’.
Activation Type
This parameter sets when the software pack activation will occur.
To Next Page
Loading...
