Technical data 117
Materials
Drive enclosure • PC/ABS 2.5 mm, color NCS 1502-Y (RAL 90021 / PMS 420 C)
• hot-dip zinc coated steel sheet 1.5 to 2.5 mm, thickness of coating 100
micrometers, color NCS 1502-Y
Package Plywood and cardboard. Foam cushions PP-E, bands PP.
Disposal The drive contains raw materials that should be recycled to preserve energy
and natural resources. The package materials are environmentally
compatible and recyclable. All metal parts can be recycled. The plastic parts
can either be recycled or burned under controlled circumstances, according
to local regulations. Most recyclable parts are marked with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and
printed circuit boards can be landfilled. The DC capacitors (C1-1 to C1-x)
contain electrolyte and the printed circuit boards contain lead, both of which
are classified as hazardous waste within the EU. They must be removed and
handled according to local regulations.
For further information on environmental aspects and more detailed recycling
instructions, please contact your local ABB distributor.
Applicable standards
The drive complies with the following standards. The compliance with the European Low Voltage Directive is
verified according to standards EN 61800-5-1 and EN 60204-1.
EN 60204-1:2006 Safety of machinery. Electrical equipment of machines. Part 1: General
requirements. Provisions for compliance: The final assembler of the machine
is responsible for installing
- emergency-stop device
- supply disconnecting device
- drive module into a cabinet.
IEC/EN 60529:1992 Degrees of protection provided by enclosures (IP code)
IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems. Part 1:
Principles, requirements and tests.
EN 61800-3:2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements
and specific test methods
EN 61800-5-1:2003 Adjustable speed electrical power drive systems. Part 5-1: Safety
requirements – electrical, thermal and energy
EN 61800-5-2:2007 Adjustable speed electrical power drive systems. Part 5-2: Safety
requirements – Functional
UL 508C:2002 UL Standard for Safety, Power Conversion Equipment, second edition
NEMA 250:2003 Enclosures for Electrical Equipment (1000 Volts Maximum)
CSA C22.2 No. 14-05 Industrial control equipment
To Next Page
Loading...
