44 Mechanical installation
Safety
WARNING! The drive module is heavy 200 kg (441 lb). Lift it by the upper part
only using the lifting lugs attached to the top of the unit. The lower part will be
deformed from lifting. Do not remove the pedestal before lifting. Do not tilt the
drive. The centre of gravity of the unit is high. The unit will overturn from a tilt of about 6
degrees. An overturning unit can cause physical injury.
Checking the installation site
The material below the drive must be non-flammable and strong enough to carry the
weight of the drive.
See chapter Technical data for the allowed operating conditions.
Required tools
• Set of screw drivers
• Torque wrench with a 500 mm (20 in.) or 2 × 250 mm (2 × 10 in.) long extension bar
• 19 mm (3/4 in.) socket, 17 mm (11/16 in.) magnetic-end socket
Do not lift by the lower
part of the frame.
M
a
x
3
0
°
Do not tilt!
To Next Page
Loading...
