Maintenance 99
Replacing the cooling fan of the module
WARNING! Follow the safety instructions, page 12. Ignoring the instructions can
cause physical injury or death, or damage to the equipment.
1. Remove the front cover.
2. Disconnect the fan capacitor and power supply wires.
3. Undo the red fastening screws of the plastic side cover of the fan. Shift the cover to the
right to free its right-hand edge and lift the cover off.
4. Undo the red fastening screws of the fan.
5. Lift the fan out of the cabinet.
6. Install the new fan and fan capacitor in reverse order to the above.
1
2
5
1
2
3
3
4
4
3
M6, 8 N·m (6 lbf·ft)
M5×8, 2 N·m (1.5 lbf·ft)
To Next Page
Loading...
