ABB ACQ810 - Efficiency; Degree of Protection; Ambient Conditions

116 Technical data
Efficiency
Approximately 98% at nominal power level
Degree of protection
IP00 (UL type open)
Ambient conditions
Environmental limits for the drive are given below. The drive is to be used in a heated, indoor, controlled
environment.
Operation
installed for stationary
use
Storage
in the protective
package
Transportation
in the protective
package
Installation site altitude 0 to 4000 m (13123 ft)
above sea level (above
1000 m [3281 ft]), see
pages 106 and 68.)
--
Air temperature -15 to +50 °C (5 to
122 °F).
No frost
allowed. See section
Ratings.
-40 to +70 °C (-40 to
+158 °F)
-40 to +70 °C (-40 to
+158 °F)
Relative humidity 5 to 95% Max. 95% Max. 95%
No condensation allowed. Maximum allowed relative humidity is 60% in the
presence of corrosive gases.
Contamination levels
(IEC 60721-3-3, IEC 60721-3-
2, IEC 60721-3-1)
No conductive dust allowed.
Boards with coating:
Chemical gases: Class
3C2
Solid particles: Class
3S2
Boards with coating:
Chemical gases: Class
1C2
Solid particles: Class
1S3
Boards with coating:
Chemical gases: Class
2C2
Solid particles: Class
2S2
Atmospheric pressure 70 to 106 kPa
0.7 to 1.05 atmospheres
70 to 106 kPa
0.7 to 1.05 atmospheres
60 to 106 kPa
0.6 to 1.05 atmospheres
Vibration (IEC 60068-2) Max. 1 mm (0.04 in.)
(5 to 13.2 Hz),
max. 7 m/s
2
(23 ft/s
2
)
(13.2 to 100 Hz)
sinusoidal
Max. 1 mm (0.04 in.)
(5 to 13.2 Hz),
max. 7 m/s
2
(23 ft/s
2
)
(13.2 to 100 Hz)
sinusoidal
Max. 3.5 mm (0.14 in.)
(2 to 9 Hz),
max. 15 m/s
2
(49 ft/s
2
)
(9 to 200 Hz) sinusoidal
Shock (IEC 60068-2-29) Not allowed
Max. 100 m/s
2
(330 ft./
s
2
), 11 ms
Max. 100 m/s
2
(330 ft./
s
2
), 11 ms
Free fall Not allowed 100 mm (4 in.) for weight
over 100 kg (220 lb)
100 mm (4 in.) for weight
over 100 kg (220 lb)