ABB ACQ810 - Layout

Operation principle and hardware description 23
 Layout
The components of the standard unit are shown below.
Front cover
Pedestal
Motor cable terminals
Input cable terminals
PE terminal
Alternative output cable
terminals (when no
vertical busbars are used)
Fastening bracket
Fastening points
Fastening points
Additional holes for
fastening the cable
terminals
Control unit
(JCU)
Lifting lug
Control cable
clamp plate
Drive module
Fastening points
Cables going to the JCU Control
Unit and APOW board are coiled on
the top of the module.
Control panel