ABB ACS 160 - H Terminal Interface

ACS 160 User’s Manual 11
H Terminal Interface
Use cable glands to ensure proper sealing, see I.
Note! The power supply input connectors are located in different places depending whether the unit
has a built-in RFI filter or not.
Note! DC voltage can be measured between R+ and X4-2.
Units with built-in RFI filter
In units with built-in RFI filter, earthing wire (PE) connectors for motor and mains are located on the
filter baseplate.
Brake resistor
cable connector
(
R-, R+)
Brake resistor
earthing wire
connector
(
, PE)
PE, mains
cable earthing
wire connector
Mains cable
connector
(
U1, V1, W1)
Control panel/
Serial link
connector
DIP switches
Main I/O
terminal, see K
(X4-1, X4-2)
Motor cable
connector, see O
(U2, V2, W2)
Motor PTC connector
Motor cable
earthing wire
connector
( , PE)
x
4
-
1
x
4
-
2
R-
R+
PE, mains cable earthing wire connector
Mains cable connector
PE, motor
cable earthing
wire connector
Motor cable
connector