Functions in the main Menu 29
Modified
In the Modified sub-menu, only the parameters whose
values differ from the Application Macro defaults are listed.
The order is determined by the parameter number.
Adding parameters to the Home view
When you view a read-only parameter in the Parameters menu, you can add the
parameter to the Home view.
• Pressing (Add to view) opens the Home view
in the editing mode, so you can add the parameter
to an empty display slot or replace an existing
parameter with it.
• Pressing (Back) takes you back to the
parameter view.
Editing the Home view functions are described in more detail in Editing the contents
of the Home view on page 38.
Editing parameters
You can edit parameter values with the arrow keys.
1. Select the desired parameter from the list by pressing
(Select).
2. Press (Edit).
3. Use and to change the value.
4. Press (Save) to save the value, or press (Cancel) to exit the
parameter view and discard any changes.
5. Press + to restore the default value of the parameter (this does not save it).
See the sections below for more information on editing specific parameter types.
Editing numeric parameters
Numeric parameters include parameters with linear numeric values, passcodes, time
and date parameters, durations and exception dates. For numeric parameters with
linear values, the minimum and maximum values are displayed in the bottom left and
right corners of the content area, respectively.
• Use and to highlight digits.
• Use and to change the value.
• Press (Save) to save the value and exit the view.
Assistant Panel Guide Rev B.book Page 29 Tuesday, April 10, 2012 12:08 PM
To Next Page
Loading...
