ABB ACS-AP Series - Editing Bit-Field Parameters

Functions in the main Menu 31
1. Select Other to move to a list of parameter groups.
2. Select a parameter group to move to a list of
parameters
3. Depending on the parameter you are editing, you must
select a parameter or an individual bit, or you may
choose either of the two.
• If the right softkey label is Select, you must select
an individual bit as the value of the parameter you
are editing. Press (Select) to move to a bit
selection list.
• If the right softkey label is Save, you can select that
parameter as the value of the parameter you are
editing. Press (Save) to save the selection.
• If the right softkey label is Save and there is also an
arrow on the right hand side of the selection, you
can choose an individual bit or all the bits in that
parameter. Press to move to a bit selection list.
If you want select all the bits in the parameter, press
(Save) instead.
4. Select a bit if applicable (see the previous step).
Pressing inverts the selected bit and (Save)
saves the selection.
The parameter or bit is now selected as the parameter
value.
 Editing bit-field parameters
A bit-field parameter is a bit word whose individual bits can
be edited. The labels describe the function of each bit, and
the current state of the bit is shown as 1 or 0.
• Use and to select a bit.
• To change a bit value, press or .
• To save the bit values and exit, press (Save).
• To cancel and exit, press (Cancel).
2
3
4
1
Assistant Panel Guide Rev B.book Page 31 Tuesday, April 10, 2012 12:08 PM