Functions in the main Menu 33
Energy efficiency
In the Energy efficiency menu, you can view and configure parameters related to
energy savings, such as kWh counters.
Event log
In the Event log menu, you can view information collected
on faults and warnings. Events are automatically logged.
See Fault tracing on page 45 for more information on faults
and warnings.
In the Primary faults sub-menu, you can view the faults
that have tripped the drive. In the Other events sub-menu, you can view all other
faults, and all warnings.
History graphs
The History graphs menu has two submenus: Trends and Load profile.
Trends
This functionality is available in a future release.
Load profile
In the Load profile submenu, you can view and configure
load profiles. The menu contains the following sub-menus:
• Amplitude logger 1: opens a Histogram view, which
displays the motor current as a distribution histogram.
This logger cannot be reset.
• Amplitude logger 2: opens a Histogram view, which
displays the contents of an amplitude logger as a
distribution histogram. You can select the signal to be
monitored.
• Load profile configuration: select the signal to be
monitored in Amplitude logger 2.
• Peak value logger: select a signal to be monitored by
a peak value logger.
For more information on load profiles, see the appropriate firmware manual.
Assistant Panel Guide Rev B.book Page 33 Tuesday, April 10, 2012 12:08 PM
To Next Page
Loading...
